Standard Withdrawn, No replacement   Last Updated: Dec 31, 2010 Track Document
ASTM D1757-03

Standard Test Method for Sulfate Sulfur in Ash from Coal and Coke (Withdrawn 2009)

Standard Test Method for Sulfate Sulfur in Ash from Coal and Coke (Withdrawn 2009) D1757-03 ASTM|D1757-03|en-US Standard Test Method for Sulfate Sulfur in Ash from Coal and Coke (Withdrawn 2009) Standard new BOS Vol. 05.06 Committee D05
$ 0.00 Out of stock

Significance and Use

Laboratory furnace temperature and furnace ventilation have an influence on SO3 retention in laboratory ash. Consequently, sulfur in ash as determined in the laboratory cannot be assumed to be equivalent to sulfur present in the mineral matter in coal or to the retention of sulfur in ash produced under the conditions of commercial utilization.

The sulfate sulfur determined by these test methods can be used to calculate the sulfur trioxide portion of ash so that the ash content or ash composition can be reported on a sulfur trioxide free basis.

Scope

1.1 This test method pertains to the determination of sulfate sulfur in coal or coke ash.

1.2 The values stated in SI units (Practice E 380) shall be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center