Standard Withdrawn, No replacement   Last Updated: Jul 06, 2023 Track Document
ASTM D1665-20

Standard Test Method for Engler Specific Viscosity of Tar Products (Withdrawn 2023)

Standard Test Method for Engler Specific Viscosity of Tar Products (Withdrawn 2023) D1665-20 ASTM|D1665-20|en-US Standard Test Method for Engler Specific Viscosity of Tar Products (Withdrawn 2023) Standard new BOS Vol. 04.03 Committee D04
$ 0.00 Out of stock
ASTM International

Significance and Use

5.1 This test method is useful in characterizing the consistency of tar and tar distillates by measuring their flow properties. It is applicable to materials that are readily liquid at temperatures up to 100 °C.

Scope

1.1 This test method covers the determination of specific viscosity of tars and their fluid products. It does not determine absolute viscosity, but is an empirical flow test. Only by conforming strictly to requirements of the test method are reproducible results obtained.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center