Standard Historical Last Updated: Aug 04, 2020 Track Document
ASTM D1622/D1622M-14

Standard Test Method for Apparent Density of Rigid Cellular Plastics

Standard Test Method for Apparent Density of Rigid Cellular Plastics D1622_D1622M-14 ASTM|D1622_D1622M-14|en-US Standard Test Method for Apparent Density of Rigid Cellular Plastics Standard new BOS Vol. 08.01 Committee D20
$ 66.00 In stock

Significance and Use

4.1 If the material to be tested includes forming skins, the apparent overall density, or the apparent core density, or both, shall be determined. If the material does not have forming skins, the term overall density is not applicable.

4.2 This test method is also applicable to spray foam materials.

4.3 Before proceeding with this test method, reference shall be made to the specification of the material being tested. Any test specimen preparation, conditioning, dimensions, or testing parameters, or combination thereof, covered in the relevant ASTM materials specification shall take precedence over those mentioned in this test method. If there are no relevant ASTM material specifications, then the default conditions in this method apply.

4.4 When density or apparent density is used in reference to a cellular plastic, without further qualification, it shall be interpreted as follows:

4.4.1 density—shall be interpreted as being the apparent overall density if the material is to be used with forming skins intact.

4.4.2 density—shall be interpreted as the apparent core density if the forming skins have been, or will be, removed before the material is used.


1.1 This test method covers the density of a cellular plastic. Density can be evaluated as the apparent overall density (includes forming skins) or by apparent core density (forming skins removed).

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1This test method is equivalent to ISO 845.
Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.22
Pages: 4
DOI: 10.1520/D1622_D1622M-14
ICS Code: 83.100