Standard Active Last Updated: Oct 04, 2023 Track Document
ASTM D1596-14(2023)

Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material

Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material D1596-14R23 ASTM|D1596-14R23|en-US Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material Standard new BOS Vol. 15.10 Committee D10
$ 61.00 In stock
ASTM International

Significance and Use

5.1 Dynamic cushioning test data obtained by this test method are applicable to the cushioning material and not necessarily the same as obtained in a package. In addition to the influence of the package, the data can also be affected by the specimen area, thickness, loading rate, and other factors.

Scope

1.1 This test method covers a procedure for obtaining dynamic shock cushioning characteristics of packaging materials through acceleration-time data achieved from dropping a falling guided platen assembly onto a motionless sample. This test method does not address any effects or contributions of exterior packaging assemblies.

1.2 The data acquired may be used for a single point or for use in developing a dynamic cushion curve for the specific material being tested. Such data may be used for comparison among different materials at specific input conditions, or qualifying materials against performance specifications. Caution should be used when attempting to compare data from different methods or when using such data for predicting in-package performance. Depending upon the particular materials of concern, correlation of such data (from among differing procedures or for predicting in–package performance) may be highly variable.

Note 1: Alternative and related method for possible consideration is Test Method D4168.

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.10
Developed by Subcommittee: D10.13
Pages: 4
DOI: 10.1520/D1596-14R23
ICS Code: 55.040