Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D1510-07a

Standard Test Method for Carbon Black-Iodine Adsorption Number

Standard Test Method for Carbon Black-Iodine Adsorption Number D1510-07A ASTM|D1510-07A|en-US Standard Test Method for Carbon Black-Iodine Adsorption Number Standard new BOS Vol. 09.01 Committee D24
$ 75.00 In stock

Scope

1.1 This test method covers the determination of the iodine adsorption number of carbon black.

1.1.1 Procedure A is the original procedure for this determination.

1.1.2 Procedure B specifies an increased sample mass of carbon black and volume of iodine solution (the ratio is the same as in Procedure A) which results in a simplified formula for the calculation of the iodine number.

1.2 The iodine adsorption number of carbon black has been shown to decrease with sample aging. New SRB HT Iodine Standards have been produced that exhibit stable iodine number upon aging. These SRB HT Iodine Standards are recommended for daily monitoring (x-charts) of testing and for standardization of iodine testing (see Section 8 ) when target values cannot be obtained.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D24.21
Pages: 8
DOI: 10.1520/D1510-07A
ICS Code: 83.040.20