Standard Active Last Updated: Nov 05, 2019 Track Document
ASTM D1369-19

Standard Practice for Quantities of Materials for Asphalt-Aggregate Surface Treatments

Standard Practice for Quantities of Materials for Asphalt-Aggregate Surface Treatments D1369-19 ASTM|D1369-19|en-US Standard Practice for Quantities of Materials for Asphalt-Aggregate Surface Treatments Standard new BOS Vol. 04.03 Committee D04
$ 61.00 In stock

Significance and Use

4.1 This practice is intended to be used as a guide by those involved in the design of asphalt surface treatments. It covers typical application rates for the various types of surface treatments and covers aggregate sizes and recommended grades of asphaltic material for both hot and cool weather conditions.

4.2 The typical asphalt material application rates given are for normal surfaces and non-porous aggregates. Provision is made for rate adjustment when other than normal surfaces or porous aggregates, or both, are involved.

Scope

1.1 This practice covers the rates of application of asphalt materials and aggregates and types and grades of asphalt materials for single and multiple asphalt surface treatments as applied to suitably prepared pavements or bases.

1.2 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.24
Pages: 4
DOI: 10.1520/D1369-19
ICS Code: 91.100.50; 93.080.20