Standard Historical Last Updated: Aug 16, 2017
ASTM D1037-06

Standard Test Methods for Evaluating Properties of Wood-Base Fiber and Particle Panel Materials


1.1 Part A-General Test Methods for Evaluating the Basic Properties of Wood-Base Fiber and Particle Panel Materials These test methods cover the determination of the properties of wood-base fiber and particle panel materials that are produced as mat-formed panels such as particleboard, medium-density fiberboard and hardboard. Some of the test methods are applicable to other panel products such as oriented strand board. The test methods are as follows:

1.3 There are accepted basic test procedures for various fundamental properties of materials that may be used without modification for evaluating certain properties of wood-based fiber and particle panel materials. These test methods are included elsewhere in the Annual Book of ASTM Standards. The pertinent ones are listed in . A few of the test methods referenced are for construction where the wood-base materials often are used.

1.4 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are approximate in many cases. 1 in. = 25.4 mm, 1 lbf = 4.45 N.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.10
Developed by Subcommittee: D07.03
Pages: 30
DOI: 10.1520/D1037-06
ICS Code: 79.040