Standard Active Last Updated: Feb 04, 2020 Track Document
ASTM D950-03(2020)e1

Standard Test Method for Impact Strength of Adhesive Bonds

Standard Test Method for Impact Strength of Adhesive Bonds D0950-03R20E01 ASTM|D0950-03R20E01|en-US Standard Test Method for Impact Strength of Adhesive Bonds Standard new BOS Vol. 15.06 Committee D14
$ 55.00 In stock

Significance and Use

4.1 Adhesives can fail under a sudden impact load and not under a slowly applied load of the same or greater force.

4.2 This test method can be used to compare the sensitivity of various adhesives to suddenly applied loads.


1.1 This test method covers the determination of the comparative impact strength of adhesive bonds in shear, when tested on standard specimens under specified conditions of preparation, conditioning, and testing.

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 15.06
Developed by Subcommittee: D14.80
Pages: 4
DOI: 10.1520/D0950-03R20E01
ICS Code: 83.180