Standard Historical Last Updated: Nov 12, 2012 Track Document
ASTM D858-07

Standard Test Methods for Manganese in Water

Standard Test Methods for Manganese in Water D0858-07 ASTM|D0858-07|en-US Standard Test Methods for Manganese in Water Standard new BOS Vol. 11.01 Committee D19
$ 75.00 In stock

Significance and Use

Elemental constituents in potable water, receiving water, and wastewater need to be identified for support of effective pollution control programs. Test Methods A, B, and C provide the techniques necessary to make such measurements.

Although inhaled manganese dusts have been reported to be toxic to humans, manganese normally is ingested as a trace nutrient in both food and water. Because it is considered to be relatively nontoxic to man, as well as aquatic life, a limit of 50 μg/L has been established in the EPA National Secondary Drinking Water Regulations. This limit is based primarily on its ability to stain laundry and produce objectionable tastes in beverages.

Manganese does not occur naturally as a metal but is found in various salts and minerals, frequently in association with iron compounds. Manganese is not mined in the United States except when manganese is contained in iron ores that are deliberately used to form ferro-manganese alloys. Manganese salts are used as fertilizer additives and are commonly found in surface and ground waters.


1.1 These test methods cover the atomic absorption determination of dissolved and total recoverable manganese in water and certain wastewaters. Three test methods are given as follows:

Test Method Concentration RangeSections
A-Atomic Absorption, Direct 0.1 to 5 mg/L7 to 15
B-Atomic Absorption, Chelation-Extraction 10 to 500 g/L16 to 24
C-Atomic Absorption, Graphite Furnace 5 to 50 g/L25 to 33

1.2 Test Methods A, B, and C were used successfully on reagent grade and natural waters. Other matrices used in the study were brine (Test Method B), effluent from a wood treatment plant, and condensate from a medium BTU coal gasification process (Test Method C). It is the user's responsibility to ensure the validity of a test method for waters of untested matrices.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 11.7, 20.2, 20.9, and 22.10.

1.3 Former Test Method A (Colorimetric) was discontinued. For historical information, see Appendix X1.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 11.01
Developed by Subcommittee: D19.05
Pages: 8
DOI: 10.1520/D0858-07
ICS Code: 13.060.50