Standard Historical Last Updated: Nov 11, 2013 Track Document
ASTM D792-08

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement D0792-08 ASTM|D0792-08|en-US Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement Standard new BOS Vol. 08.01 Committee D20
$ 83.00 In stock

Significance and Use

The specific gravity or density of a solid is a property that is conveniently measured to identify a material, to follow physical changes in a sample, to indicate degree of uniformity among different sampling units or specimens, or to indicate the average density of a large item.

Changes in density of a single material are due to localized differences in crystallinity, loss of plasticizer, absorption of solvent, or to other causes. It is possible that portions of a sample differ in density because of their differences in crystallinity, thermal history, porosity, and composition (types or proportions of resin, plasticizer, pigment, or filler).

Density is useful for calculating strength-weight and cost-weight ratios.

Scope

1.1 These test methods describe the determination of the specific gravity (relative density) and density of solid plastics in forms such as sheets, rods, tubes, or molded items.

1.2 Two test methods are described:

1.2.1 Test Method AFor testing solid plastics in water, and

1.2.2 Test Method BFor testing solid plastics in liquids other than water.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This standard is not equivalent to ISO 11831 Method A. This test method provides more guidelines on sample weight and dimension. ISO 1183-1 allows testing at an additional temperature of 27 ± 2°C.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.70
Pages: 6
DOI: 10.1520/D0792-08
ICS Code: 83.080.01