Standard Historical Last Updated: Dec 04, 2020 Track Document
ASTM D705-99(2012)

Standard Specification for Urea-Formaldehyde Molding Compounds

Standard Specification for Urea-Formaldehyde Molding Compounds D0705-99R12 ASTM|D0705-99R12|en-US Standard Specification for Urea-Formaldehyde Molding Compounds Standard new BOS Vol. 08.01 Committee D20
$ 66.00 In stock


This specification covers the testing and requirements for two types of compression-molding, thermosetting urea-formaldehyde molding compounds. Type 1 are general purpose molding compounds with alpha-cellulose fillers, while, Type 2 are general purpose molding compounds with cellulose fillers other than alpha-cellulose. The molding compounds shall be of uniform composition, and the apparent density, bulk factor, plasticity, particle size, and color shall be compounded as to conform to the requirements prescribed herein. Also, sampled test specimens shall be examined and conform correspondingly to the following physical requirements: specific gravity; flexural strength; impact resistance; water absorption; dielectric strength; and arc resistance.


1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in 3.1.

1.2 The values stated in SI units are to be regarded as the standard.

Note 1The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.
Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.16
Pages: 2
DOI: 10.1520/D0705-99R12
ICS Code: 83.140.99