Standard Active Last Updated: Mar 19, 2021 Track Document
ASTM D623-07(2019)e1

Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression

Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression D0623-07R19E01 ASTM|D0623-07R19E01|en-US Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression Standard new BOS Vol. 09.01 Committee D11
$ 83.00 In stock

Significance and Use

4.1 Because of wide variations in service conditions, no correlation between these accelerated tests and service performance is given or implied. However, the test methods yield data that can be used to estimate relative service quality of different compounds. They are often applicable to research and development studies.

Scope

1.1 These test methods may be used to compare the fatigue characteristics and rate of heat generation of different rubber vulcanizates when they are subjected to dynamic compressive strains.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D11.15
Pages: 7
DOI: 10.1520/D0623-07R19E01
ICS Code: 83.060