Standard Historical Last Updated: Jul 28, 2023 Track Document
ASTM D564-87(2017)

Standard Test Methods for Liquid Paint Driers

Standard Test Methods for Liquid Paint Driers D0564-87R17 ASTM|D0564-87R17|en-US Standard Test Methods for Liquid Paint Driers Standard new BOS Vol. 06.01 Committee D01
$ 73.00 In stock
ASTM International

Significance and Use

3.1 Driers accelerate the drying of oil, paint, printing ink, and varnish.

3.2 These test methods are applicable to liquid driers manufactured for use in paints and related coatings.

3.3 The tests for metallic content using ethylenediaminetetraacetic acid dihydrate (EDTA) are intended for concentrated solutions of single metals; two or more metals may cause interference.

Scope

1.1 These test methods cover the test procedures to be applied to liquid paint driers used in paints and related coatings. Typical paint driers, listed in Specification D600, are carboxylates of lead, cobalt, manganese, zinc, iron, calcium, and zirconium.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 06.01
Developed by Subcommittee: D01.21
Pages: 3
DOI: 10.1520/D0564-87R17
ICS Code: 87.060.99