Standard Active Last Updated: Mar 06, 2023 Track Document
ASTM D312/D312M-16a(2023)

Standard Specification for Asphalt Used in Roofing

Standard Specification for Asphalt Used in Roofing D0312_D0312M-16AR23 ASTM|D0312_D0312M-16AR23|en-US Standard Specification for Asphalt Used in Roofing Standard new BOS Vol. 04.04 Committee D08
$ 61.00 In stock

Abstract

This specification covers four types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The asphalts shall be prepared from crude petroleum. Asphalts shall be classified as: Type I; Type II; Type III; and Type IV. Asphalts of each type shall conform to the physical properties prescribed. Tests shall be performed to determine the properties of the material in accordance with the following methods: sampling; softening point; flash point; penetration; ductility; and solubility.

Scope

1.1 This specification covers four types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The specification is intended for general classification purposes only, and does not imply restrictions on the slope at which an asphalt must be used.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.03
Pages: 2
DOI: 10.1520/D0312_D0312M-16AR23
ICS Code: 91.100.50