Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D70-09

Standard Test Method for Density of Semi-Solid Bituminous Materials (Pycnometer Method)

Standard Test Method for Density of Semi-Solid Bituminous Materials (Pycnometer Method) D0070-09 ASTM|D0070-09|en-US Standard Test Method for Density of Semi-Solid Bituminous Materials (Pycnometer Method) Standard new BOS Vol. 04.03 Committee D04
$ 66.00 In stock

Significance and Use

Values of density are used for converting volumes to units of mass, and for correcting measured volumes from the temperature of measurement to a standard temperature using Practice D 4311.

Scope

1.1 This test method covers the determination of the relative density and density of semi-solid bituminous materials, asphalt cements, and soft tar pitches by use of a pycnometer.

Note 1—An alternate method for determining the density of semi-solid and solid bituminous materials is Test Method D 3289. For materials which are too fluid for use of this test method, use Test Method D 3142.

1.2 The values stated in SI units are to the regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.47
Pages: 4
DOI: 10.1520/D0070-09
ICS Code: 91.100.50