Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C1197-04

Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method

Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method C1197-04 ASTM|C1197-04|en-US Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method Standard new BOS Vol. 04.05 Committee C15
$ 83.00 In stock

Significance and Use

Deformation and strength properties are measured only on the masonry between flatjacks. Boundary effects of the collar joint behind the wythe tested and adjacent masonry are neglected. In the case of multi-wythe masonry, deformability is estimated only in the wythe in which the flatjack is inserted. Deformability of other wythes may be different.

Scope

1.1 This test method describes an in situ method for determining the deformation properties of existing unreinforced solid-unit masonry. This test method concerns the measurement of in-situ masonry deformability properties in existing masonry by use of thin, bladder-like flatjack devices that are installed in saw cut mortar joints in the masonry wall. This test method provides a relatively non-destructive means of determining masonry properties.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.05
Developed by Subcommittee: C15.04
Pages: 5
DOI: 10.1520/C1197-04
ICS Code: 91.060.10