Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM C1147-01

Standard Practice for Determining the Short Term Tensile Weld Strength of Chemical-Resistant Thermoplastics

Standard Practice for Determining the Short Term Tensile Weld Strength of Chemical-Resistant Thermoplastics C1147-01 ASTM|C1147-01|en-US Standard Practice for Determining the Short Term Tensile Weld Strength of Chemical-Resistant Thermoplastics Standard new BOS Vol. 08.01 Committee D20
$ 73.00 In stock

Scope

1.1 This practice covers the preparation and evaluation of joints between two pieces of weldable grades of thermoplastic materials, backed and unbacked, (such as those shown in Table 1) up to 2 in. (50 mm) in thickness.

1.2 Since there are numerous new technologies and techniques constantly being developed for plastic welding, there are no profiles and procedures that can be considered as standard for all plastics at various thicknesses. This practice is not intended to define profiles and procedures; however, it is intended to establish methods to evaluate minimum short term weld factors to be achieved by the welder for the respective plastics.

1.3 Weld procedures used for test pieces should reflect procedures to be used in actual fabrication.

1.4 Welding methods to be used could include machine welding, extrusion welding, and hot gas welding.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.19
Pages: 4
DOI: 10.1520/C1147-01
ICS Code: 83.080.20