Standard Historical Last Updated: Jan 11, 2017 Track Document
ASTM C926-16b

Standard Specification for Application of Portland Cement-Based Plaster

Standard Specification for Application of Portland Cement-Based Plaster C0926-16B ASTM|C0926-16B|en-US Standard Specification for Application of Portland Cement-Based Plaster Standard new BOS Vol. 04.01 Committee C11
$ 91.00 In stock

Abstract

This specification covers the standard requirements for the application of full thickness Portland cement-based plaster for exterior (stucco) and interior work. It also sets forth tables for proportioning of various plaster mixes and plaster thickness. The materials used shall consist of the following: cement which shall be a Portland cement, air-entraining Portland cement, masonry cement, blended hydraulic cement, air-entraining blended hydraulic cement, or plastic cement; Type S hydrated lime; aggregates such as perlite and sand for base and job-mixed finish coats; water to be used in mixing; admixtures; and fibers. Surfaces of solid bases such as masonry, stone, cast-in-place or precast concrete shall be prepared either by sandblasting, wire brushing, acid etching, chipping, or a combination thereof. Details on curing to resist cracking; materials protection and storage; environmental conditions; and application of plaster, finish-coat, and fog-coat, which shall be done by hand or machine up to the specified nominal thickness on metal and solid plaster bases are discussed.

Scope

1.1 This specification covers the requirements for the application of full thickness portland cement-based plaster for exterior (stucco) and interior work.

1.2 This specification sets forth tables for proportioning of various plaster mixes and plaster thickness.

Note 1: General information will be found in Annex A1. Design considerations will be found in Annex A2.

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI (metric) values given in parentheses are approximate and are provided for information purposes only.

1.4 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.5 Details of construction for a specific assembly to achieve the required fire resistance shall be obtained from reports of fire-resistance tests, engineering evaluations, or listings from recognized fire testing laboratories.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.01
Developed by Subcommittee: C11.03
Pages: 14
DOI: 10.1520/C0926-16B
ICS Code: 91.100.10