Standard Historical Last Updated: Jun 07, 2011 Track Document
ASTM C595/C595M-10

Standard Specification for Blended Hydraulic Cements

Standard Specification for Blended Hydraulic Cements C0595_C0595M-10 ASTM|C0595_C0595M-10|en-US Standard Specification for Blended Hydraulic Cements Standard new BOS Vol. 04.01 Committee C01
$ 83.00 In stock

Abstract

This specification pertains to blended hydraulic cements for both general and special applications, using slag or pozzolan, or both, with portland cement or portland cement clinker, or slag with lime. These cements are classified into three types: Type IS which is portland blast-furnace slag cement, Type IP which is portland-pozzolan cement, and Type IT which is ternary blended cement. They can also be described according to air-entraining, moderate sulfate resistance, moderate heat of hydration, high sulfate resistance, or low heat of hydration properties. In addition, the cement shall undergo different tests to determine properties such as: chemical analysis, fineness by sieving, fineness by air-permeability, autoclave expansion, time of setting, air content of mortar and compressive strength. Additional optional testing such as heat of hydration and sulfate resistance is also included.

Scope

1.1 This specification pertains to blended hydraulic cements for both general and special applications, using slag or pozzolan, or both, with portland cement or portland cement clinker or slag with lime.

Note 1—This specification prescribes ingredients and proportions, with some performance requirements whereas Performance Specification C1157 is a hydraulic cement specification in which performance criteria alone govern the products and their acceptance.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Values in SI units [or inch-pound units] shall be obtained by measurement in SI units [or inch-pound units] or by appropriate conversion, using the Rules for Conversion and Rounding given in , of measurements made in other units [or SI units]. Values are stated in only SI units when inch-pound units are not used in practice.

1.3 The text of this standard refers to notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) are not requirements of the standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.01
Developed by Subcommittee: C01.10
Pages: 8
DOI: 10.1520/C0595_C0595M-10
ICS Code: 91.100.10