Standard Historical Last Updated: Jan 12, 2018 Track Document
ASTM C25-11e2

Standard Test Methods for Chemical Analysis of Limestone, Quicklime, and Hydrated Lime

Standard Test Methods for Chemical Analysis of Limestone, Quicklime, and Hydrated Lime C0025-11E02 ASTM|C0025-11E02|en-US Standard Test Methods for Chemical Analysis of Limestone, Quicklime, and Hydrated Lime Standard new BOS Vol. 04.01 Committee C07
$ 119.00 In stock

Significance and Use

4.1 These test methods provide accurate and reliable analytical procedures to determine the chemical constituents of limestone, quicklime, and hydrated lime (See Note 1). The percentages of specific constituents which determine a material's quality or fitness for use are of significance depending upon the purpose or end use of the material. Results obtained may be used in relation to specification requirements.

4.2 Because quicklime and hydrated lime quickly absorb water and carbon dioxide from the air, precision and bias are extremely dependent upon precautions taken during sample preparation and analysis to minimize excessive exposure to ambient conditions.

Note 1: These test methods can be applied to other calcareous materials if provisions are made to compensate for known interferences.

Scope

1.1 These test methods cover the chemical analysis of high-calcium and dolomitic limestone, quicklime, and hydrated lime. These test methods are classified as either standard (preferred) or alternative (optional).

1.2 The standard test methods are those that employ classical gravimetric or volumetric analytical procedures and are typically those required for referee analyses where chemical specification requirements are an essential part of contractual agreement between buyer and seller.

1.3 Alternative or optional test methods are provided for those who wish to use procedures shorter or more convenient than the standard methods for the routine determinations of certain constituents. Optional test methods may sometimes be preferred to the standard test methods, but frequently the use of modern and expensive instrumentation is indicated which may not be accessible to everyone. Therefore, the use of these test methods must be left to the discretion of each laboratory.

1.4 The analytical procedures appear in the following order:

 

Section

Aluminum Oxide 

15

Available Lime Index 

28

Calcium and Magnesium Oxide:

 Alternative EDTA Titration Method 

31

Calcium Carbonate Equivalent 

33

Calcium Oxide:

 Gravimetric Method 

16

 Volumetric Method 

17

Carbon Dioxide by Standard Method 

22

Combined Oxides of Iron and Aluminum 

12

Ferrous Iron 

Appendix X5

Free Calcium Oxide 

Appendix X6

Free Moisture in Hydrated Lime 

21

Free Moisture in Limestone 

20

Free Silica 

29

Insoluble Matter Including Silicon Dioxide:

 Standard Method 

8

 Optional Perchloric Acid Method 

9

Insoluble Matter Other Than Silicon Dioxide 

11

Loss on Ignition 

19

Magnesium Oxide 

18

Manganese:

 Bismuthate Method 

Appendix X4

 Periodate (Photometric) Method 

27

pH Determination of Alkaline Earth Solutions 

34

Phosphorus:

 Titrimetric Method 

Appendix X3

 Molybdovanadate Method 

26

Silicon Dioxide 

10

Strontium Oxide 

Appendix X2

Sulfur Trioxide 

23

Total Carbon:

 Direct Combustion-Thermal Conductivity Cell Method

32

Total Carbon and Sulfur:

 Combustion/Infrared Detection Method 

35

Total Iron:

 Standard Method, Potassium Dichromate Titration 

13

 Potassium Permanganate Titration Method 

Appendix X1

 Ortho-Phenanthroline, Photometric Method 

14

Total Sulfur:

 Sodium Carbonate Fusion 

24

 Combustion-Iodate Titration Method 

25

 Unhydrated Oxides 

30

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 9.3, 10.2.1, 18.4.3, 31.6.4.2, X2.3.1, and X5.4.1.1.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.01
Developed by Subcommittee: C07.05
Pages: 38
DOI: 10.1520/C0025-11E02
ICS Code: 91.100.10