Standard Withdrawn, No replacement   Last Updated: Jan 14, 2015 Track Document
ASTM B736-00(2006)

Standard Specification for Aluminum, Aluminum Alloy and Aluminum-Clad Steel Cable Shielding Stock (Withdrawn 2015)

Standard Specification for Aluminum, Aluminum Alloy and Aluminum-Clad Steel Cable Shielding Stock (Withdrawn 2015) B0736-00R06 ASTM|B0736-00R06|en-US Standard Specification for Aluminum, Aluminum Alloy and Aluminum-Clad Steel Cable Shielding Stock (Withdrawn 2015) Standard new BOS Vol. 02.02 Committee B07
$ 0.00 Out of stock

Abstract

This specification covers selected uncoated or coated aluminum, aluminum alloy, and aluminum clad steel cable shielding stocks used for electrostatic or electromagnetic shielding in insulated power, control, instrumentation, and communication cables including coaxial cables. Claddings may be bonded to the base metal by any method, provided it can produce a clad material that conforms to the requirements. Aluminum materials should be furnished in Temper 0 while aluminum clad steel materials should be in the annealed temper. When specified, cable shielding stock may be coated with a protective plastic coating on one or both sides.

Scope

1.1 This specification covers selected aluminum, aluminum-alloy and aluminum clad steel cable shielding stock, both uncoated and coated, for applications such as electrostatic or electromagnetic shielding for insulated power, control, instrumentation and communication cables (including coaxial cable). Note 1See B 694, Specification for Copper, Copper Alloy, and Copper-Clad Stainless Steel Sheet and Strip for Electrical Cable Shielding for related standards for copper-based shielding materials.

1.2 The materials covered are the following:

Aluminum 1060 Aluminum designations are in accordance with ANSI H35.1. The equivalent Unified Numbering System alloy designations are those shown preceded by A9, for example, A91100 for Aluminum 1100 in accordance with Practice E 527.

Cladding ratio must be specified (see 5.4).

Type of MaterialCoating
none
Aluminum 1100none
Aluminum 1145none
Aluminum 1235none
Alloy 3003none
Aluminum 1060polyolefin
Aluminum 1100polyolefin
Aluminum 1145polyolefin
Aluminum 1235polyolefin
Alloy 3003polyolefin
Aluminum 1060vinyl resin
Aluminum 1100vinyl resin
Aluminum 1145vinyl resin
Aluminum 1235vinyl resin
Alloy 3003vinyl resin
Aluminum Clad Steelnone
Aluminum Clad Steelpolyolefin

1.3 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A2.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

The following precautionary caveat pertains only to the test method portion, Section 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center