Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM B680-80(2004)

Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution

Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution B0680-80R04 ASTM|B0680-80R04|en-US Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution Standard new BOS Vol. 02.05 Committee B08
$ 73.00 In stock

Significance and Use

This test method describes a destructive test procedure for measuring the degree of seal of the porosity in anodic oxide coatings. Low coating mass loss is an indication of good seal quality and of the ability of the coating to resist staining and blooming in many types of service.

This test method is suitable for quality control purposes within manufacturing operations and for determining whether anodized parts meet seal quality requirements in applicable specifications.

Scope

1.1 This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution.

1.2 This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important.

1.3 This test method is not applicable to:

1.3.1 Hard coatings, which normally are not sealed.

1.3.2 Anodic coatings that have been sealed only in dichromate solutions.

1.3.3 Anodic coatings that have undergone a treatment to render them hydrophobic.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.05
Developed by Subcommittee: B08.07
Pages: 2
DOI: 10.1520/B0680-80R04
ICS Code: 25.220.40