Standard Active Last Updated: May 12, 2021 Track Document
ASTM B507-14(2021)

Standard Practice for Design of Articles to Be Electroplated on Racks

Standard Practice for Design of Articles to Be Electroplated on Racks B0507-14R21 ASTM|B0507-14R21|en-US Standard Practice for Design of Articles to Be Electroplated on Racks Standard new BOS Vol. 02.05 Committee B08
$ 63.00 In stock

Significance and Use

2.1 When an article is to be electroplated, it is necessary to consider not only the characteristics of the electroplating process, but also the design of the part to minimize electroplating and finishing costs and solution dragout as well as to improve appearance and functionality. It is often possible during the design and engineering stages to make small adjustments in shape that will result in considerable benefit toward a better quality part at a lower cost.

2.2 The specific property of an electroplating process that would require some attention to the details of optional designs, is the throwing power of the electroplating solution. This term describes the properties of the solution as it relates to the solution electrical resistance and solution capacitance at the cathode and overall efficiency of the electrolyte system. Throwing power is defined as the improvement of the coating distribution over the primary current distribution on an electrode (usually cathode) in a given solution, under specified conditions.

Scope

1.1 This practice covers design information for parts to be electroplated on racks. The recommendations contained herein are not mandatory, but are intended to give guidance toward good practice.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.05
Developed by Subcommittee: B08.01
Pages: 5
DOI: 10.1520/B0507-14R21
ICS Code: 25.220.20