Standard Active Last Updated: Aug 09, 2024 Track Document
ASTM B428-24

Standard Test Method for Angle of Twist in Rectangular and Square Copper and Copper Alloy Tube

Standard Test Method for Angle of Twist in Rectangular and Square Copper and Copper Alloy Tube B0428-24 ASTM|B0428-24|en-US Standard Test Method for Angle of Twist in Rectangular and Square Copper and Copper Alloy Tube Standard new BOS Vol. 02.01 Committee B05
$ 61.00 In stock
ASTM International

Significance and Use

4.1 The rectangular or square copper alloy tube covered by this test method may be used in applications in which control of twist is important to proper fit in final assembly and to minimize rework to bring the tube into compliance. It is recognized that the amount of twist, in degrees per increment of length, can change as a result of the weight of the product and its length during measurement.

4.2 This test method provides a procedure for measuring the twist in square and rectangular copper and copper alloy tubes as a measure of the deviation from straightness.

4.3 This test method allows the purchaser and supplier or manufacturer to inspect square and rectangular copper and copper alloy tube with a standard technique that provides acceptable twist in delivered tubes.

Scope

1.1 This test method covers the requirements for the determination of the angle of twist in rectangular and square copper and copper alloy tube.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.06
Pages: 3
DOI: 10.1520/B0428-24
ICS Code: 23.040.15