Standard Active Last Updated: Nov 01, 2024 Track Document
ASTM B355-11(2024)

Standard Specification for Nickel-Coated Soft or Annealed Copper Wire

Standard Specification for Nickel-Coated Soft or Annealed Copper Wire B0355-11R24 ASTM|B0355-11R24|en-US Standard Specification for Nickel-Coated Soft or Annealed Copper Wire Standard new BOS Vol. 02.03 Committee B01
$ 69.00 In stock
ASTM International

Abstract

This specification covers nickel-coated, soft or annealed, round copper wire for use in electrical equipment. Five classes of wire are covered as follows: Class 2, Class 4, Class 7, Class 10, and Class 27. Properties like elongation, resistivity and dimensions of the wire shall be determined. The continuity of the coating shall be determined by the sodium polysulfide test. Adherence of the coating shall be determined by wrapping and immersion tests.

Scope

1.1 This specification covers nickel-coated, soft or annealed, round copper wire for use in electrical equipment.

1.2 Five classes of wire are covered as follows:

1.2.1 Class 2—Wire whose nickel coating is at least 2 % of the total weight of the coated wire.

1.2.2 Class 4—Wire whose nickel coating is at least 4 % of the total weight of the coated wire.

1.2.3 Class 7—Wire whose nickel coating is at least 7 % of the total weight of the coated wire.

1.2.4 Class 10—Wire whose nickel coating is at least 10 % of the total weight of the coated wire.

1.2.5 Class 27—Wire whose nickel coating is at least 27 % of the total weight of the coated wire.

Note 1: For information purposes, the thickness of coating in microinches provided by the percentages listed in 1.2 is shown in Table 1.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parenthesis are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1 Exceptions—The SI values for density, resistivity, and volume are to be regarded as standard.

1.4 This hazard statement applies only to Section 6, Test Methods, and to the Appendix of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.03
Developed by Subcommittee: B01.04
Pages: 8
DOI: 10.1520/B0355-11R24
ICS Code: 77.150.30