Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM B124/B124M-08

Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes

Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes B0124_B0124M-08 ASTM|B0124_B0124M-08|en-US Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes Standard new BOS Vol. 02.01 Committee B05
$ 83.00 In stock

Abstract

This specification establishes the requirements for copper (UNS Nos. C11000, C14500, and C14700) and copper alloy (UNS Nos. C36500, C37000, C37700, C46400, C48200, C48500, C61900, C62300, C63000, C63200, C64200, C64210, C65500, C67500, C67600, C69300, C70620, C71520, and C77400) forging rods, bars, and shapes. The material for manufacture shall be a cast rod, bar, or billet of such purity and soundness as to be suitable for processing by hot working, cold working, and annealing to produce a uniform wrought structure in the finished product. Products shall be produced in tempers H50 (extruded and drawn), M20 (as hot rolled), and M30 (as hot extruded). Products shall be tested and shall adhere to dimensional (diameter, thickness, width, length, shape, and straightness), mechanical, and chemical composition requirements.

Scope

1.1 This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging. The following coppers and copper alloys are involved:

Copper UNS Nos.
Copper Alloy UNS Nos.
C11000C36500
C14500C37000
C14700C37700
C46400
C48200
C48500
C61900
C62300
C63000
C63200
C64200
C64210
C65500
C67500
C67600
C69300
C70620
C71520
C77400


Note 1—Additional information about forging practice and forgings produced from these alloys is given in Appendix X1 and in Specification B 283.

1.2 UnitsThe values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.02
Pages: 5
DOI: 10.1520/B0124_B0124M-08
ICS Code: 77.150.30