E-Learning

ASTM D4629 Standard Test Method for Trace Nitrogen in Liquid Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection - eLearning Course

accredited iacet provider
Price: $174
About the Course

This test method covers the determination of the trace total nitrogen naturally found in liquid hydrocarbons boiling in the range from approximately 50 degrees C to 400 degrees C, with viscosities between approximately 0.2 cSt and 10 cSt (mm2/s) at room temperature. This test method is applicable to naphthas, distillates, and oils containing 0.3 mg/kg to 100 mg/kg total nitrogen. For liquid hydrocarbons containing more than 100 mg/kg total nitrogen, Test Method D5762 can be more appropriate. This test method has been successfully applied, during interlaboratory studies, to sample types outside the range of the scope by dilution of the sample in an appropriate solvent to bring the total nitrogen concentration and viscosity to within the range covered by the test method. However, it is the responsibility of the analyst to verify the solubility of the sample in the solvent and that direct introduction of the diluted sample by syringe into the furnace does not cause low results due to pyrolysis of the sample or solvent in the syringe needle.

The course takes approximately 1 hour to complete and includes instructional video content, interactive knowledge checks, and a self-grading quiz. Downloadable resources include a pdf of the standard.

Learning Outcomes

By the end of this course, you will be able to:

  • Recall the apparatus used for the determination of the trace total nitrogen naturally found in liquid hydrocarbons
  • Identify the reagents used in this test method, including the nitrogen stock solution
  • Describe the steps for calibration and standardization, including volumetric and gravimetric methods
  • List the steps for the procedure
  • Identify the calculations for nitrogen content
  • List the reporting requirements for this test method
  • Recall the steps for quality assurance/quality control (QA/QC)

Audience

Anyone who runs the D4629 test method or who needs an understanding of the test method and how it is properly run.

Certificate and CEUs

CEUs: .1

Certificate: A certificate is available upon successful completion of the course and an 80% or higher score on the exam.

ASTM Standards Referenced

ASTM D4629

Related Products

This training course is part of the following eLearning program(s):

Access

1 year online subscription for a Single-User Only via username/password. Requires internet access.

For pricing for Multi-User access or for more information, please contact sales here or call 1-877-909-ASTM.

Stock #

TRAIN-D4629-PASS