Standard Active Last Updated: May 30, 2024 Track Document
ASTM A1125/A1125M-24

Standard Specification for Wire Rod for Bridge Cable Wire

Standard Specification for Wire Rod for Bridge Cable Wire A1125_A1125M-24 ASTM|A1125_A1125M-24|en-US Standard Specification for Wire Rod for Bridge Cable Wire Standard new BOS Vol. 01.03 Committee A01
$ 61.00 In stock
ASTM International

Scope

1.1 This specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to wire rod for bridge cable wire.

1.2 This specification is applied to wire rod with a nominal diameter of 11.0 mm [7/16 in.] to 16.0 mm [5/8 in.] intended for use in bridge cable wire.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.03
Developed by Subcommittee: A01.03
Pages: 4
DOI: 10.1520/A1125_A1125M-24
ICS Code: 77.140.60