Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM A1064/A1064M-09

Standard Specification for Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete

Standard Specification for Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete A1064_A1064M-09 ASTM|A1064_A1064M-09|en-US Standard Specification for Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete Standard new BOS Vol. 01.04 Committee A01
$ 83.00 In stock

Abstract

This specification covers the material, dimensional and mechanical property requirements for plain and deformed steel wire and welded wire reinforcements produced from hot-rolled rods that are to be used for the reinforcement of concrete. Tension test procedures are detailed for each type of wire reinforcement to examine their adherence to specified tensile strength, yield strength, and reduction of area requirements.

Scope

1.1 This specification covers steel wire and welded wire reinforcement produced from hot-rolled rod to be used for the reinforcement of concrete. The steel wire is cold-worked, drawn or rolled, plain (non-deformed, as-drawn or galvanized), or deformed. Welded wire reinforcement is made from plain or deformed wire, or a combination of plain and deformed wire. Common wire sizes and dimensions are given in Table 1, Table 2, Table 3, and Table 4. Actual wire sizes are not restricted to those shown in the tables.

Note 1—Welded wire for concrete reinforcement has historically been described by various terms: welded wire fabric, WWF, fabric, and mesh. The wire reinforcement industry has adopted the term welded wire reinforcement (WWR) as being more representative of the applications of the products being manufactured. Therefore, the term welded wire fabric has been replaced with the term welded wire reinforcement in this specification and in related specifications.

1.2 Supplement S1 describes high-strength wire, which manufacturers furnish when specifically ordered. Manufacturers furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and the manufacturer.

1.3 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text the SI units are shown in brackets (except in Table 2 and Table 4). The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.04
Developed by Subcommittee: A01.05
Pages: 10
DOI: 10.1520/A1064_A1064M-09
ICS Code: 77.140.15