Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM A971-00

Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils

Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils A0971-00 ASTM|A0971-00|en-US Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils Standard new BOS Vol. 03.07 Committee A06
$ 66.00 In stock

Scope

1.1 This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill.

1.2 The values stated in either customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

1.3 The following material specifications include requirements for edge taper or crown: A677, A677M, A683/A683M, A726, A840, A840M, and A876/A876M.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.07
Developed by Subcommittee: A06.01
Pages: 4
DOI: 10.1520/A0971-00
ICS Code: 77.140.50