Standard Historical Last Updated: May 21, 2024 Track Document
ASTM A704/A704M-19e1

Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement

Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement A0704_A0704M-19E01 ASTM|A0704_A0704M-19E01|en-US Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement Standard new BOS Vol. 01.04 Committee A01
$ 66.00 In stock
ASTM International

Abstract

This specification covers materials in mat (or sheet) form fabricated from hot-rolled, plain steel bars or rods to be used for the reinforcement of concrete. Mats consist of two layers of bars or rods that are assembled by welding at right angles to each other. Welding shall be done in such a way that the minimum tensile strength, yield strength, and elongation requirements shall be met. Tension and shear tests shall be performed to meet the required strength and elongation properties and maximum size of a bar or rod material. A retest shall be performed when a specimen fails to meet the specified requirements. All tests and inspections shall be made at the place of fabrication prior to shipment, unless otherwise specified, and shall be so conducted as not to interfere unnecessarily with fabricating operations.

Scope

1.1 This specification covers material in mat (or sheet) form fabricated from hot-rolled, plain steel bars or rods to be used for the reinforcement of concrete. Mats are made from two layers of bars or rods that are assembled by welding the intersections at right angles to each other.

1.2 This specification is applicable for orders in either inch-pound units (as A704) or in SI units [as A704M].

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

1.4 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.04
Developed by Subcommittee: A01.05
Pages: 3
DOI: 10.1520/A0704_A0704M-19E01
ICS Code: 77.140.15