Standard Active Last Updated: Nov 08, 2019 Track Document
ASTM A610-79(2019)

Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size

Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size A0610-79R19 ASTM|A0610-79R19|en-US Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size Standard new BOS Vol. 01.02 Committee A01
$ 61.00 In stock

Abstract

This specification covers standard methods for sampling and testing of various ferroalloys for size analysis. Ferroalloys are classified into lump and crushed or plates sizes. The small-sized samples subject to screen testing shall be taken from the lot sample by riffling, and larger sized samples by mixing and quartering. Sizing of lumps shall be done by visual examination. Crushed or plates materials shall be subjected to sieving by using either manually driven or mechanically driven screen vibrators to divide samples into several size fractions.

Scope

1.1 These test methods cover procedures for the sampling and testing of the various ferroalloys for sizing, either before or after shipment from the plants of the manufacturers.

1.2 They are designed to give results representative of each lot that will be comparable with the manufacturer's certified analysis for the same lot.

1.3 The purchaser may use any sampling procedure he desires, but the results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these test methods.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4.1 Exception—The SI units that correspond to mesh sizes in Table 1 are to be regarded as standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.02
Developed by Subcommittee: A01.18
Pages: 2
DOI: 10.1520/A0610-79R19
ICS Code: 77.100