Standard Active Last Updated: Nov 06, 2023 Track Document
ASTM A576-23

Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality

Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality A0576-23 ASTM|A0576-23|en-US Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality Standard new BOS Vol. 01.05 Committee A01
$ 69.00 In stock
ASTM International

Abstract

This specification covers hot-wrought special quality carbon steel bars. Special quality bar applications include forging, heat treating, cold drawing, machining, and many structural uses. The steel shall be made by one or more of the following primary processes: open-hearth, basic-oxygen, or electric furnace. The heat analysis shall conform to the requirements for chemical composition specified.

Scope

1.1 This specification covers hot-wrought special quality carbon steel bars. Special quality bar applications include forging, heat treating, cold drawing, machining, and many structural uses. A guide for the selection of steel bars is contained in Practice A400.

1.2 The bars shall be furnished in the grades specified in Table 1. Sections and sizes of bar steel available are covered in Specification A29/A29M. Hot-wrought special quality carbon steel bars are produced in cut lengths and coils; the manufacturer should be consulted regarding sections and sizes available in coils, produced to a chemical composition.

Rephosphorized and Resulfurized Carbon SteelE, G, H

Designation

Grade

Carbon

Manganese

Phosphorus

Sulfur

Lead

G12110

1211

0.13 max

0.60–0.90

0.07–0.12

0.10–0.15

...

G12120

1212

0.13 max

0.70–1.00

0.07–0.12

0.16–0.23

...

G12130

1213

0.13 max

0.70–1.00

0.07–0.12

0.24–0.33

...

G12150

1215

0.09 max

0.75–1.05

0.04–0.09

0.26–0.35

...

...

12L14

0.15 max

0.85–1.15

0.04–0.09

0.26–0.35

0.15–0.35

1.3 Merchant quality hot-wrought carbon steel bars are covered in Specification A575.

1.4 Some end uses may require superior surface quality, or special chemical restrictions, metallurgical characteristics, heat treatment, or surface finishes which the purchaser may obtain by designating one or more of the available Supplementary Requirements.

1.5 The values stated in inch-pound units are to be regarded as standard.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.05
Developed by Subcommittee: A01.15
Pages: 6
DOI: 10.1520/A0576-23
ICS Code: 77.140.60