Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM A530/A530M-04a

Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe

Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe A0530_A0530M-04A ASTM|A0530_A0530M-04A|en-US Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe Standard new BOS Vol. 01.01 Committee A01
$ 75.00 In stock

Abstract

This specification covers a general requirements for specialized carbon and alloy steel pipe. Tensile tests, tension tests, flattening tests, hydrostatic tests and ultrasonic tests shall be made to conform to the requirements specified. If the mechanical results do not conform to the requirements specified, retests shall be made. Defects in seamless pipe shall be repaired by welding.

Scope

1.1 This specification covers a group of requirements which, with the exceptions of Section 5.3, Section 13, Section 20, and Section 21, are mandatory requirements to the ASTM pipe product specifications noted below unless the product specification specifies different requirements, in which case the requirement of the product specification shall prevail.

1.2 Sections 5.3 or 20 are mandatory if the product specification has a requirement for product analysis or flattening tests.

1.3 Section 21 is mandatory if the product specification has a hydrostatic test requirement without defining the test parameters.

1.4 Section 13 is for information only.

1.5 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification, only the requirement of the product specification need be satisfied.

These designations refer to the latest issue of the respective specifications.

Title of Specification ASTM Designation
Seamless Carbon Steel Pipe for High-Temperature ServiceA 106
Metal-Arc-Welded Steel Pipe for Use With High-Pressure Transmission SystemsA 381
Centrifugally Cast Ferritic Alloy Steel Pipe for High-Temperature ServiceA 426
Centrifugally Cast Austenitic Steel Pipe for High-Temperature ServiceA 451
Seamless Carbon Steel Pipe for Atmospheric and Lower TemperaturesA 524
Centrifugally Cast Iron-Chromium-Nickel High-AlloyTubing for Pressure Application at High Temperatures A 608
Centrifugally Cast Carbon Steel Pipe for High-Temperature ServiceA 660
Electric-Fusion-Welded Steel Pipe for Atmospheric and Lower Temperatures A 671
Electric-Fusion-Welded Steel Pipe for High-Pressure Service at Moderate TemperaturesA 672
Carbon and Alloy Steel Pipe, Electric-Fusion-Welded for High-Pressure Service at High Temperatures A 691
Centrifugally Cast Ferritic/Austenitic Stainless Steel Pipe for Corrosive Environments A 872

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order.

Note 1—The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as "nominal diameter," "size," and "nominal size."

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.01
Developed by Subcommittee: A01.09
Pages: 9
DOI: 10.1520/A0530_A0530M-04A
ICS Code: 23.040.10