Standard Historical Last Updated: Jan 13, 2016 Track Document
ASTM A479/A479M-15

Standard Specification for Stainless Steel Bars and Shapes for Use in Boilers and Other Pressure Vessels

Standard Specification for Stainless Steel Bars and Shapes for Use in Boilers and Other Pressure Vessels A0479_A0479M-15 ASTM|A0479_A0479M-15|en-US Standard Specification for Stainless Steel Bars and Shapes for Use in Boilers and Other Pressure Vessels Standard new BOS Vol. 01.03 Committee A01
$ 83.00 In stock

Abstract

This specification covers hot- and cold-finished bars of stainless steel, including rounds, squares, and hexagons, and hot-rolled or extruded shapes such as angles, tees, and channels for use in boiler and pressure vessel construction. Four grades of the stainless steel are available which includes austenitic, austenitic-ferritic, ferritic, and martensitic grades. Mechanical properties such as tensile strength, yield strength, elongation, and hardness shall be determined for the specimens subjected to normalized, tempered, annealed, and quenched conditions. The austenitic stainless steels shall be subjected to heat treatment and shall undergo corrosion test.

Scope

1.1 This specification2 covers hot- and cold-finished bars of stainless steel, including rounds, squares, and hexagons, and hot-rolled or extruded shapes such as angles, tees, and channels for use in boiler and pressure vessel construction.2

Note 1: There are standards covering high nickel, chromium, austenitic corrosion, and heat-resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B02.07 and may be found in Annual Book of ASTM Standards, Vol 02.04.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.03
Developed by Subcommittee: A01.17
Pages: 8
DOI: 10.1520/A0479_A0479M-15
ICS Code: 77.140.30