Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM A450/A450M-04

Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes

Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes A0450_A0450M-04 ASTM|A0450_A0450M-04|en-US Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes Standard new BOS Vol. 01.01 Committee A01
$ 83.00 In stock

Scope

1.1 This specification covers a group of requirements which, with the exceptions of 4.3 and Sections 5, 6, 17, 18, 19, 20, 21, 22, and 23, are mandatory requirements to the following ASTM tubular product specifications:

These designations refer to the latest issue of the respective specifications.

Title of SpecificationASTM Designation
Electric-Resistance-Welded Carbon Steel and Carbon Manganese Steel Boiler TubesA 178/A 178M
Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser TubesA 179/A 179M
Seamless Carbon Steel Boiler Tubes for High-Pressure ServiceA 192/A 192M
Seamless Medium-Carbon Steel Boiler and Superheater Tubes A 210/A 210M
Electric-Resistance-Welded Carbon Steel Heat-Exchanger and Condenser TubesA 214/A 214M
Seamless and Electric-Welded Low-Alloy Steel Tubes A 423/A 423M
Electric-Resistance-Welded Coiled Steel Tubing for Gasand Fuel Oil Lines A 539
Seamless Cold-Drawn Carbon Steel Feedwater Heater TubesA 556/A 556M
Seamless, Cold-Drawn Carbon Steel Tubing for Hydraulic System ServiceA 822

1.2 One or more of Sections 4.3, 5, 6, 17, 18, 19, 20, 20.1, 22, and 23 apply when the product specification or purchase order has a requirement for the test or analysis described by these sections.

1.3 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification only the requirement of the product specification need be satisfied.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.01
Developed by Subcommittee: A01.09
Pages: 10
DOI: 10.1520/A0450_A0450M-04
ICS Code: 23.040.10