Standard Historical Last Updated: Oct 09, 2013 Track Document
ASTM A313/A313M-10e1

Standard Specification for Stainless Steel Spring Wire

Standard Specification for Stainless Steel Spring Wire A0313_A0313M-10E01 ASTM|A0313_A0313M-10E01|en-US Standard Specification for Stainless Steel Spring Wire Standard new BOS Vol. 01.03 Committee A01
$ 75.00 In stock

Abstract

This guide covers standard specification for austenitic and age-hardenable stainless steel round spring wire intended especially for the manufacture of springs. The steel shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, molybdenum, nitrogen, and other elements. The material shall conform to the required tensile strengths following the prescribed heat treatment. Tensile strength requirements for hardened wires and stress-relieved materials shall be given. Mechanical tests such as wrap test, uniformity (coil test), and bend test hall be performed on the steel material.

Scope

1.1 This specification covers austenitic and age-hardenable stainless steel round spring wire intended especially for the manufacture of springs.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 Unless the order specifies an M designation, the material shall be furnished to inch-pound units.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.03
Developed by Subcommittee: A01.17
Pages: 8
DOI: 10.1520/A0313_A0313M-10E01
ICS Code: 77.140.25