ASTM WK43374

    New Test Method for Measurement of Thermal Effusivity of Fabrics Using a Modified Transient Plane Source (MTPS) Instrumen

    (What is a Work Item?)

    Developed by Subcommittee: D13.51 | Committee D13 | Contact Staff Manager


    1. Scope

    1.1 This test method covers the quantitative measurement of thermal effusivity of woven, knitted, or non-woven fabrics using a guarded modified transient plane source (MTPS) instrument. This test method is applicable to a wide range of thicknesses; however, the thickness of the specimen shall be greater than the penetration depth of the heat flux during the measurement time. 1.2 This test method is comparative since specimens of known thermal effusivity are used to calibrate the apparatus at the factory level. Thermal effusivity of the calibration specimens are confirmed through calculations that use established properties of thermal conductivity, density, and specific heat. 1.3 This test method is intended for measuring fabrics in a dry state at ambient conditions. 1.4 Units-The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    fabrics; heat transfer; modified transient plane source; textiles; thermal effusivity


    This test method measures thermal effusivity, which is the transient heat exchange between a fabric specimen and a heated surface. It has been established that there is a strong correlation between thermal effusivity and thermal sensations (that is, warm or cold feeling), in which lower values indicate sensations of warmth and higher values indicate sensations of coolness. This fabric property is important to assist product developers with appropriate fabric selection. This draft test method is being re-balloted as many revisions were made after the last subcommittee ballot.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:

    Technical Contact:
    Shannon Yawney