ASTM F722 - 18

    Standard Specification for Welded Joints for Shipboard Piping Systems

    Active Standard ASTM F722 | Developed by Subcommittee: F25.11

    Book of Standards Volume: 01.07


      Format Pages Price  
    PDF 11 $54.00   ADD TO CART
    Hardcopy (shipping and handling) 11 $54.00   ADD TO CART
    Standard + Redline PDF Bundle 22 $65.00   ADD TO CART



    Abstract

    This specification covers typical details of welded joints commonly used in shipboard piping systems. These joints and other joints may be used provided the welding procedures used have been qualified in accordance with the applicable regulatory rules and regulations. The maximum butt weld reinforcement of differnet nominal wall thicknesses of pipe or tube shall be discussed.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers typical details of welded joints commonly used in shipboard piping systems. These joints and other joints may be used provided the welding procedures used have been qualified in accordance with the applicable regulatory rules and regulations.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    ICS Code

    ICS Number Code 25.160.40 (Welding joints and welds)

    UNSPSC Code

    UNSPSC Code 25110000(Marine transport)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F0722-18

    Citation Format

    ASTM F722-18, Standard Specification for Welded Joints for Shipboard Piping Systems, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top