If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F482 - 09(2020)

    Standard Practice for Corrosion of Aircraft Metals by Total Immersion in Maintenance Chemicals

    Active Standard ASTM F482 | Developed by Subcommittee: F07.07

    Book of Standards Volume: 15.03

      Format Pages Price  
    PDF 5 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $52.00   ADD TO CART

    Significance and Use

    3.1 This practice not only provides information on the accumulated effects of corrosion at specific time periods under a given set of conditions, but also provides information on the initial rate of corrosion of virgin metal, the corrosion rate of metal per unit time after long exposure, and the initial corrosion rate of virgin metal after long exposure of the corroding fluid to metal. The test also provides a means of determining the direction corrosion will take with time, although causes for increase or decrease in the corrosiveness and corrodibility of media and metal (such as passive film formation or destruction, depletion of corrosive contaminate, and so forth) as a function of time are not given.

    1. Scope

    1.1 This practice covers the determination of the corrosiveness of tank-type aircraft maintenance chemicals on aircraft metals and the corrodibility of metals in these maintenance chemicals with time. The determination is made under conditions of total immersion by a combination of weight change measurements and visual qualitative determinations of change.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautions, see Section 6.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D235 Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)

    D329 Specification for Acetone

    D1193 Specification for Reagent Water

    E1 Specification for ASTMLiquid-in-Glass Thermometers

    ICS Code

    ICS Number Code 49.025.05 (Ferrous alloys in general); 49.025.15 (Non-ferrous alloys in general)

    UNSPSC Code

    UNSPSC Code 25130000(Aircraft)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F0482-09R20

    Citation Format

    ASTM F482-09(2020), Standard Practice for Corrosion of Aircraft Metals by Total Immersion in Maintenance Chemicals, ASTM International, West Conshohocken, PA, 2020, www.astm.org

    Back to Top