| ||Format||Pages||Price|| |
|19||$58.00||  ADD TO CART|
|Hardcopy (shipping and handling)||19||$58.00||  ADD TO CART|
|Standard + Redline PDF Bundle||38||$69.00||  ADD TO CART|
1.1 This terminology standard covers definitions of terms and concepts related to unmanned aircraft systems (UAS). It is intended to encourage the consistent use of terminology throughout all ASTM unmanned aircraft system standards and is intended to complement Standard Terminology for Aircraft. Terms already included in Terminology are not duplicated here.
1.2 A definition adapted from a particular standard within the ASTM F38 collection of standards is not limited to use within only those standards.
1.3 Additional terms specific to a given standard may be defined solely within that standard and not included here.
1.4 Units—The definitions of units will be as defined in NIST SP 330, and will not be duplicated in this document. NIST SP 330 is available on the internet. The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
F2395 Terminology for Unmanned Aircraft Systems
F2908 Specification for Unmanned Aircraft Flight Manual (UFM) for an Unmanned Aircraft System (UAS)
F2909 Specification for Continued Airworthiness of Lightweight Unmanned Aircraft Systems
F3060 Terminology for Aircraft
F3196 Practice for Seeking Approval for Beyond Visual Line of Sight (BVLOS) Small Unmanned Aircraft System (sUAS) Operations
F3298 Specification for Design, Construction, and Verification of Lightweight Unmanned Aircraft Systems (UAS)
F3322 Specification for Small Unmanned Aircraft System (sUAS) Parachutes
F3330 Specification for Training and the Development of Training Manuals for the UAS Operator
F3364 Practice for Independent Audit Program for Unmanned Aircraft Operators
F3365 Practice for Compliance Audits to ASTM Standards on Unmanned Aircraft Systems
F3366 Specification for General Maintenance Manual (GMM) for a small Unmanned Aircraft System (sUAS)
F3379 Guide for Training for Public Safety Remote Pilot of Unmanned Aircraft Systems (UAS) Endorsement
F3389/F3389M Test Method for Assessing the Safety of Small Unmanned Aircraft Impacts
F3411 Specification for Remote ID and Tracking
F3442/F3442M Specification for Detect and Avoid System Performance Requirements
Other Documents14 CFR 107 Small Unmanned Aircraft Systems Available from U.S. Government Publishing Office (GPO), 732 N. Capitol St., NW, Washington, DC 20401, http://www.gpo.gov.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM F3341 / F3341M-20a, Standard Terminology for Unmanned Aircraft Systems, ASTM International, West Conshohocken, PA, 2020, www.astm.orgBack to Top