ASTM F3240 - 17

    Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines

    Active Standard ASTM F3240 | Developed by Subcommittee: F17.67

    Book of Standards Volume: 08.04


      Format Pages Price  
    PDF 5 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $46.00   ADD TO CART


    Significance and Use

    5.1 This practice is for use by designers and specifiers, regulatory agencies, owners, and inspection organizations that are involved in the rehabilitation of main and lateral pipelines and manholes. As for any practice, modifications may be required for specific job conditions.

    1. Scope

    1.1 This practice covers the requirements for the installation of seamless molded hydrophilic gaskets (SMHG) in cured-in-place pipe (CIPP) rehabilitation of main and lateral pipelines.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 There is no similar or equivalent ISO Standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1149 Test Methods for Rubber DeteriorationCracking in an Ozone Controlled Environment

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2240 Test Method for Rubber PropertyDurometer Hardness

    F412 Terminology Relating to Plastic Piping Systems

    F1216 Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube

    F1743 Practice for Rehabilitation of Existing Pipelines and Conduits by Pulled-in-Place Installation of Cured-in-Place Thermosetting Resin Pipe (CIPP)

    F2019 Practice for Rehabilitation of Existing Pipelines and Conduits by the Pulled in Place Installation of Glass Reinforced Plastic (GRP) Cured-in-Place Thermosetting Resin Pipe (CIPP)

    F2561 Practice for Rehabilitation of a Sewer Service Lateral and Its Connection to the Main Using a One Piece Main and Lateral Cured-in-Place Liner

    F2599 Practice for The Sectional Repair of Damaged Pipe By Means of An Inverted Cured-In-Place Liner

    NASSCO Guidelines

    PACP NASSCO Pipeline Assessment & Certification Program

    ISO Standard

    ISO 17025


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F3240-17

    Citation Format

    ASTM F3240-17, Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top