If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F3124 - 15e1

    Standard Practice for Data Recording the Procedure used to Produce Heat Butt Fusion Joints in Plastic Piping Systems or Fittings

    Active Standard ASTM F3124 | Developed by Subcommittee: F17.20

    Book of Standards Volume: 08.04

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART

    Significance and Use

    5.1 The Device record includes information about how the heat butt fusion joint was made (heater temperature, pressures and times for the heating, fusion and cooling steps) and other important information about the process, job, equipment used, etc. The Device record is compared to the specified heat butt fusion procedure parameters to determine if the procedure was followed correctly. For comparison purposes, a graph of time versus pressure is generated from the data record to show pressure changes that occur during the butt fusion process. Comparing the time versus pressure graph to the steps in the procedure helps determine that the procedure parameters were observed. (See Appendix X1.) These records may be downloaded from the device and stored.

    1. Scope

    1.1 This practice specifies the data recording information that is recorded, when data recording equipment is used, on butt fusion joints in a plastic piping system in order to compare the procedure used in making the joint to the heat butt fusion joining procedure specified. This practice is suitable for use with all heat butt fusion joining procedures that require measurable time and pressure profiles, such as Practice F2620, Specification F2785, Specification F2945 international standards or other qualified procedures. This practice applies to hydraulically operated heat butt fusion machines only and does not apply to manually operated fusion machines or specialized fabrication equipment for fittings in a controlled environment with proprietary procedures and processes.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F2620 Practice for Heat Fusion Joining of Polyethylene Pipe and Fittings

    F2785 Specification for Polyamide 12 Gas Pressure Pipe, Tubing, and Fittings

    F2945 Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings

    ICS Code

    ICS Number Code 23.040.60 (Flanges, couplings and joints)

    UNSPSC Code

    UNSPSC Code 40170000(Pipe piping and pipe fittings); 43211730(Data acquisition system)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F3124-15E01

    Citation Format

    ASTM F3124-15e1, Standard Practice for Data Recording the Procedure used to Produce Heat Butt Fusion Joints in Plastic Piping Systems or Fittings, ASTM International, West Conshohocken, PA, 2015, www.astm.org

    Back to Top