If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F3066 / F3066M - 18

    Standard Specification for Aircraft Powerplant Installation Hazard Mitigation

    Active Standard ASTM F3066 / F3066M | Developed by Subcommittee: F44.40

    Book of Standards Volume: 15.09


      Format Pages Price  
    PDF 7 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 7 $52.00   ADD TO CART
    Standard + Redline PDF Bundle 14 $62.00   ADD TO CART



    1. Scope

    1.1 This specification covers minimum requirements for hazard mitigation in propulsion systems installed on small aeroplanes.

    1.2 The applicant for a design approval must seek the individual guidance to their respective CAA body concerning the use of this standard as part of a certification plan. For information on which CAA regulatory bodies have accepted this standard (in whole or in part) as a means of compliance to their Small Aircraft Airworthiness regulations (Hereinafter referred to as “the Rules”), refer to ASTM F44 webpage (www.ASTM.org/COMITTEE/F44.htm) which includes CAA website links.

    1.3 Units—The values stated are SI units followed by imperial units in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F3060 Terminology for Aircraft

    F3061/F3061M Specification for Systems and Equipment in Small Aircraft

    F3062/F3062M Specification for Aircraft Powerplant Installation

    F3114 Specification for Structures

    F3116/F3116M Specification for Design Loads and Conditions

    F3120/F3120M Specification for Ice Protection for General Aviation Aircraft

    Federal Aviation Regulations

    14 CFR Part 23


    ICS Code

    ICS Number Code 49.050 (Aerospace engines and propulsion systems)

    UNSPSC Code

    UNSPSC Code 25202000(Aircraft power systems)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F3066_F3066M-18

    Citation Format

    ASTM F3066 / F3066M-18, Standard Specification for Aircraft Powerplant Installation Hazard Mitigation, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top