| ||Format||Pages||Price|| |
|17||$58.00||  ADD TO CART|
|Hardcopy (shipping and handling)||17||$58.00||  ADD TO CART|
|Standard + Redline PDF Bundle||34||$69.00||  ADD TO CART|
1.1 This terminology contains a listing of terms, abbreviations, acronyms, and symbols related to aircraft covered by ASTM Committees F37 and F44 airworthiness design standards. It is intended to ensure the consistent use of terminology throughout all ASTM light aircraft standards.
1.2 Units—The definitions of units will be as defined in NIST SP 330 and will not be duplicated in this document. NIST SP 330 is available on the internet. The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 Source References—The listed document(s) was/were the original source for the definition. However, the definition may have been edited for use in this document and the F37 and F44 standards, and may not completely match the original in every respect.
1.4 A definition adapted from a particular standard within the ASTM aircraft collection of standards is not limited to use within only those standards.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
F2241 Specification for Continued Airworthiness System for Powered Parachute Aircraft
F2242 Specification for Production Acceptance Testing System for Powered Parachute Aircraft
F2243 Specification for Required Product Information to be Provided with Powered Parachute Aircraft
F2244 Specification for Design and Performance Requirements for Powered Parachute Aircraft
F2245 Specification for Design and Performance of a Light Sport Airplane
F2249 Specification for In-Service Test Methods for Temporary Grounding Jumper Assemblies Used on De-Energized Electric Power Lines and Equipment
F2279 Practice for Quality Assurance in the Manufacture of Fixed Wing Light Sport Aircraft
F2295 Practice for Continued Operational Safety Monitoring of a Light Sport Aircraft
F2317/F2317M Specification for Design of Weight-Shift-Control Aircraft
F2352 Specification for Design and Performance of Light Sport Gyroplane Aircraft
F2354 Specification for Continued Airworthiness System for Lighter-Than-Air Light Sport Aircraft
F2355 Specification for Design and Performance Requirements for Lighter-Than-Air Light Sport Aircraft
F2356 Specification for Production Acceptance Testing System for Lighter-Than-Air Light Sport Aircraft
F2411 Specification for Design and Performance of an Airborne Sense-and-Avoid System
F2415 Practice for Continued Airworthiness System for Light Sport Gyroplane Aircraft
F2425 Specification for Continued Airworthiness System for Weight-Shift-Control Aircraft
F2426 Guide on Wing Interface Documentation for Powered Parachute Aircraft
F2427 Specification for Required Product Information to be Provided with Lighter-Than-Air Light Sport Aircraft
F2449 Specification for Manufacturer Quality Assurance Program for Light Sport Gyroplane Aircraft
F2457 Specification for Required Product Information to be Provided withWeight-Shift-Control Aircraft
F2483 Practice for Maintenance and the Development of Maintenance Manuals for Light Sport Aircraft
F2490 Guide for Aircraft Electrical Load and Power Source Capacity Analysis
F2506 Specification for Design and Testing of Light Sport Aircraft Propellers
F2507 Specification for Recreational Airpark Design
F2512 Practice for Quality Assurance in the Manufacture of Light Unmanned Aircraft System
F2563 Practice for Kit Assembly Instructions of Aircraft Intended Primarily for Recreation
F2564 Specification for Design and Performance of a Light Sport Glider
F2584 Practice for Maintenance and Development of Maintenance Manuals for Light Unmanned Aircraft System (UAS)
F2626 Terminology for Light Sport Aircraft
F2639 Practice for Design, Alteration, and Certification of Aircraft Electrical Wiring Systems
F2745 Specification for Required Product Information to be Provided with an Airplane
F2746 Specification for Pilots Operating Handbook (POH) for Light Sport Airplane
F2799 Practice for Maintenance of Aircraft Electrical Wiring Systems
F2930 Guide for Compliance with Light Sport Aircraft Standards
F2972 Specification for Light Sport Aircraft Manufacturers Quality Assurance System
F3061/F3061M Specification for Systems and Equipment in Small Aircraft
F3062/F3062M Specification for Aircraft Powerplant Installation
F3093/F3093M Specification for Aeroelasticity Requirements
F3116/F3116M Specification for Design Loads and Conditions
F3117/F3117M Specification for Crew Interface in Aircraft
F3341 Terminology for Unmanned Aircraft Systems
ICS Number Code 01.040.49 (Aircraft and space vehicle engineering (Vocabularies)); 49.020 (Aircraft and space vehicles in general)
UNSPSC Code 25130000(Aircraft)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM F3060-20, Standard Terminology for Aircraft, ASTM International, West Conshohocken, PA, 2020, www.astm.orgBack to Top