If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F3054 - 18

    Standard Practice for Operations of Amusement Railway Rides, Devices, and Facilities

    Active Standard ASTM F3054 | Developed by Subcommittee: F24.60

    Book of Standards Volume: 15.07

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART
    Standard + Redline PDF Bundle 4 $54.00   ADD TO CART

    Significance and Use

    4.1 The purpose of this practice is to delineate information and to establish procedures for the operation of an Amusement Railway Ride.

    4.2 The user of this standard shall be required to review and comply with the referenced “core” ASTM Committee F24 standards in Subsection 2.1 of this standard. Modified or alternate requirements to those standards may be required in this standard.

    1. Scope

    1.1 This practice applies to operations of amusement railway ride(s) that have a track gauge greater than or equal to 12 in. (305 mm) measured between the heads of the rails. This excludes patron powered ride vehicles specifically designed for children.

    1.2 This standard does not apply to the operation of rides, such as roller coasters, that may resemble railways, but may fall within the scope of Practice F2291 or Practice F1159 and does not apply to funiculars as defined in ANSI B77.2 or BS EN 1907.

    1.3 This standard does not apply to Amusement Railway Rides operation that are intended for use as a portable amusement ride or attraction.

    1.4 This standard does not apply to permanently installed amusement railway rides and tourist railways, and their associated track, devices and facilities that are under the jurisdiction of the Federal Railroad Administration (FRA) in whole or part or National equivalent.

    1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F770 Practice for Ownership, Operation, Maintenance, and Inspection of Amusement Rides and Devices

    F1159 Practice for Design of Amusement Rides and Devices that are Outside the Purview of Other F24 Design Standards

    F2291 Practice for Design of Amusement Rides and Devices

    Other Standards

    ANSI B77.2 Funiculars - Safety Requirements Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.

    ICS Code

    ICS Number Code 97.200.99 (Other equipment for entertainment)

    UNSPSC Code

    UNSPSC Code 49241600(Recreational equipment)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F3054-18

    Citation Format

    ASTM F3054-18, Standard Practice for Operations of Amusement Railway Rides, Devices, and Facilities, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top