| Format | Pages | Price |   |
![]() |
10 | $52.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 10 | $52.00 | ![]() |
Work Item(s) - proposed revisions of this standard
More F23.20 Standards Related Products Standard References
Significance and Use
5.1 This test method assesses the cut resistance of a material when exposed to a cutting edge under specified loads. Data obtained from this test method can be used to compare the cut resistance of different materials.
5.2 This test method only addresses that range of cutting hazards that are related to a cutting action by a smooth sharp edge across the surface of the material. It is not representative of any other cutting hazard to which the material may be subjected such as serrated edges, saw blades, or motorized cutting tools. Nor is it representative of puncture, tear, or other modes of fabric failure.
1. Scope
1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load using the Tomodynamometer (TDM-100).
1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting.
1.1.2 Test apparatus may have limitations in testing materials with a thickness greater than 20 mm.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D1000 Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
D1776 Practice for Conditioning and Testing Textiles
F1494 Terminology Relating to Protective Clothing
F1790 Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with CPP Test Equipment
ISO Standards
ISO 13997 Protective ClothingMechanical PropertiesDetermination of Resistance to Cutting by Sharp ObjectsICS Code
ICS Number Code 13.340.10 (Protective clothing)
UNSPSC Code
UNSPSC Code 46181500(Safety apparel)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/F2992_F2992M-15
Citation Format
ASTM F2992 / F2992M-15, Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with Tomodynamometer (TDM-100) Test Equipment, ASTM International, West Conshohocken, PA, 2015, www.astm.org
Back to Top