ASTM F2933 - 18

    Standard Consumer Safety Specification for Crib Mattresses

    Active Standard ASTM F2933 | Developed by Subcommittee: F15.66

    Book of Standards Volume: 15.11


      Format Pages Price  
    PDF 6 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 6 $48.00   ADD TO CART
    Standard + Redline PDF Bundle 12 $58.00   ADD TO CART



    Abstract

    This consumer safety specification establishes design requirements, testing requirements and methods, and requirements for labeling for full-size and non-full-size crib mattresses. Crib mattress produced after the approval date of this specification shall be deemed non-compliant unless it conforms to all requirements described by the specification. The standard covers calibration and standardization, test methods, and marking and labeling.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This consumer safety specification establishes design requirements, testing requirements and methods, and requirements for labeling for full-size crib mattresses, non-full-size crib mattresses, and after-market mattresses for play yards and non-full size cribs.

    1.2 No crib mattress produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.

    1.3 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3359 Test Methods for Rating Adhesion by Tape Test

    F406 Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards

    F1169 Consumer Safety Specification for Full-Size Baby Cribs

    F2194 Consumer Safety Specification for Bassinets and Cradles


    ICS Code

    ICS Number Code 97.140 (Furniture)

    UNSPSC Code

    UNSPSC Code 56101804(Cribs or playpens or accessories)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2933-18

    Citation Format

    ASTM F2933-18, Standard Consumer Safety Specification for Crib Mattresses, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top