You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F2688-08(2014)e1

    Standard Guide for System-Based, Customer-Centered Quality Plan for Manufacturers (Withdrawn 2019)

    Withdrawn Standard: ASTM F2688-08(2014)e1 | Developed by Subcommittee: F16.93


      Format Pages Price  
    PDF 9 $58.00   ADD TO CART


    Withdrawn Rationale:

    This guide establishes recommended system-based procedures to assist fastener manufacturers and alteration distributors in the development of process controls which are intended to produce quality products in a cost effective manner. These recommended system-based procedures allow an organization to continually improve operational effectiveness.

    Formerly under the jurisdiction of Committee F16 on Fasteners, this guide was withdrawn in August 2019. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 This guide establishes recommended system-based procedures to assist fastener manufacturers and alteration distributors in the development of process controls which are intended to produce quality products in a cost effective manner. These recommended system-based procedures allow an organization to continually improve operational effectiveness.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F1469 Guide for Conducting a Repeatability and Reproducibility Study on Test Equipment for Nondestructive Testing

    F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

    F1503 Practice for Machine/Process Capability Study Procedure

    F1789 Terminology for F16 Mechanical Fasteners

    F2282 Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners

    ASME Standards

    B18.18.2 Inspection and Quality Assurance for High-Volume Machine Assembly Fasteners

    NIST Program

    Malcolm Baldrige Criteria for Excellence

    ISO Standard

    ISO 16426 FastenersQuality Assurance System Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2688-08R14E01

    Citation Format

    ASTM F2688-08(2014)e1, Standard Guide for System-Based, Customer-Centered Quality Plan for Manufacturers (Withdrawn 2019), ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top