Standard Active Last Updated: May 24, 2022 Track Document
ASTM F2670-22

Standard Consumer Safety Specification for Infant Bath Tubs

Standard Consumer Safety Specification for Infant Bath Tubs F2670-22 ASTM|F2670-22|en-US Standard Consumer Safety Specification for Infant Bath Tubs Standard new BOS Vol. 15.11 Committee F15
$ 69.00 In stock

Abstract

This specification covers the performance requirements, test methods, and labeling requirements to promote the safe use of infant bath tubs. The performance requirements; restraint system, static load, suction cups requirements shall be discussed. Locking mechanism, protective components, torque, label permanence, warning permanence, static load, and suction cup shall be tested to meet the requirements prescribed.

Scope

1.1 This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of infant bath tubs. It also covers slings, pads, inserts, and similar accessories when such accessories are used with the infant bath tub.

1.2 This consumer safety specification is intended to reduce the risk of death and minimize injury to infants resulting from use and reasonably foreseeable abuse of infant bath tubs and infant bath tub accessories.

1.3 No infant bath tub or infant bath tub accessory produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.11
Developed by Subcommittee: F15.20
Pages: 13
DOI: 10.1520/F2670-22
ICS Code: 97.190